Use Properly Secured Child Safety Seats.
The overall usage of vehicle child safety seats has risen dramatically over the past 20 years, and that’s good news because child safety seats help save lives. But, safety seats can’t save lives if they aren’t used correctly. If you need a Certified Child Passenger Safety Technician in Oregon visit the Child Safety Seat website
That is why it is important to make sure they are installed properly. The first step is to read and follow the installation instructions that came with the safety seat. Next, check your vehicle owner’s manual for additional guidelines.
Keep these tips in mind when transporting small children:
Secure all children under the age of four in child safety seats in the back seat of the vehicle.
Fasten children 12 months or younger in rear-facing safety seats in the back seat, out of danger of inflating airbags. If traveling in a vehicle without a backseat, turn off the airbag if possible.
Use booster seats for older children that position the lap/shoulder belt correctly, away from the child’s face and neck.
Tighten and thread safety belts through proper paths to hold child safety seats in place. Straps should move no more than one inch at the base.
Fasten the retainer clip at armpit level and tighten straps enough to allow room for only one finger under the strap.
Remember safety seat regulations vary from state to state, so check with local law enforcement officials to make sure you are meeting state regulations.
For more information on the proper use of child safety seats, or to find a listing of local child safety seat technicians who will check for proper seat installation, visit the National Highway Traffic Safety Administration website at www.nhtsa.gov. Information about specific state laws is also available there.
You are ultimately responsible for the safety of your children in vehicles. Set the example by always wearing a seat belt and stressing the importance of safety restraints. Take all necessary precautions to keep your precious cargo safe.
{ 0 comments… add one now }